1 - Locate suitable location on wall. Preferably out of high traffic area.
2 - Measure for mounting height (typically top edge is between 3 ˝’ and 4’)
3 - Locate two adjoining studs (standard is 16” on center, 2x4 studs measure 1.5” wide). Mark hole locations on level plane at 16” centers on both studs.
4 - Drill pilot holes using 3/16” drill bit
5 - Place Tour Pak Rack® in position to loosely secure by top left hole using (1) 2”x14 screw (please note: bottom side of Tour Pak Rack® is identified by helmet holder slot)
6 - Secure right side using (1) 2” x 14 screw. Tighten left side screw. Check for level.
7 - Drill lower two lower holes and secure with remaining two 2” x 14 screws.
8 - Determine which style Tour Pak mount you are using. If Style A mounting posts are correctly positioned from factory. If Style B relocate rear mount post to position closest to wall. (Please note, all mounting post positions are filled for demonstration purposes, product is shipped with eight posts. Additional posts are available.)
 |  |
| Style A | Style B |
Tour Pak Rack® in use
 |  |